An easy solution to is to make use of your house's pre-wired telephone connections. Since phone lines are wired in parallel, you can simply connect your ATA device to the nearest phone jack. Then, every phone jack in your house (assuming you have a single line) will be available for your VOIP service.
There is one caveat!
Despite the fact that your traditional phone service may have been turned off, the wire connections still exist. The phone company may send voltage over your line, which could damage your ATA device. The solution is to disconnect the incoming connection:
1. Locate your home's telephone network interface device.

2. Open it up.

3. Disconnect the incoming wires. You should cover the ends with electrical tape. In my case, line one was the blue and white wires. The blue wire was connected to the gold screw, and the white wire was connected to the green screw.
Your telephone network interface may look different. Mine was manufactured by Siecor (which is now owned by Corning). Also, do NOT disconnect the incoming lines if you have phone service! This would be bad.
Good luck!
3 comments:
Nice. Too bad I have multiple lines.
darci
As most houses are wired for 2 lines these days, wouldn't it be easy to run the VoIP connection into the "first" line, then keep your landline on the 2nd line. That way when your broadband dies, you're not without telephone service, and you retain 911 access.
You should be able to do it... The Vonage VOIP forum discusses it.
Also, Vonage allows 911 access.
Post a Comment